每日保養事項 Daily maintenance
1、檢查空濾芯和冷卻劑液位； 1. Check air filter and coolant level. 2、檢查軟管和所有管接頭是否有泄漏情況； 2. Check the leakage of the hose and all pipe joints. 3、檢查記錄，如果易耗件已經到了更換周期必須停機予以更換； 3, check the record, if the consumable piece has already reached the replacement period, it must be stopped to replace. 4、檢查記錄，當主機排氣溫度達到或接近98攝氏度，必須清洗油冷卻器； 4, check the record, when the main engine exhaust temperature reaches or close to 98 degrees Celsius, it is necessary to clean the oil cooler. 5、檢查冷凝水排放情況，若發現排水量太小或沒有冷凝水排放，必須停機清洗水分離器。 5. Check the discharge of condensate water. If it is found that the drainage amount is too small or the condensate is not discharged, it is necessary to stop cleaning the water separator. 每月保養事項 Monthly maintenance 1、檢查油冷卻器表面，必要時予以清洗； 1. Check the surface of the oil cooler and wash it when necessary. 2、清洗后冷卻器； 2. After cleaning the cooler; 3、檢查所有電線連接情況并予以緊固； 3, check all wire connection and tighten it. 4、清潔電機吸風口表面和殼體表面的灰塵； 4. Dust on the surface of the air inlet of the clean motor and the surface of the shell. 5、清洗回油過濾器 5. Cleaning the oil recovery filter
